XenCenter

Reconfiguring a Pool to Use Another WLB Appliance

September 26, 2024

Contributed by:

You can reconfigure a pool to use a different Workload Balancing virtual appliance.

However, to prevent the old Workload Balancing appliance from inadvertently remaining configured and collecting data for the pool, disconnect the pool from the old Workload Balancing appliance before connecting the pool to the new Workload Balancing appliance.

Once the pool is disconnected from the old Workload Balancing appliance, reconnect the pool by specifying the new Workload Balancing appliance name.

To use a different Workload Balancing appliance

On the pool you want to use a different Workload Balancing appliance, from the Pool menu, select Disconnect Workload Balancing Server and select Disconnect when prompted. For instructions, see Disconnecting from Workload Balancing.
In the WLB tab, select Connect. The Connect to WLB Server dialog appears.
In the Address box, type the IP address or host name (FQDN) name of the new Workload Balancing appliance.

If the new Workload Balancing appliance uses different credentials, you must also enter the new credentials.

Note:

Enter all the information that you would normally enter when you initially connect a pool to Workload Balancing. For information, see Connecting to Workload Balancing.

XenServer 8

Workload Balancing

Citrix Hypervisor 8.2 Cumulative Update 1

Workload Balancing

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Reconfiguring a Pool to Use Another WLB Appliance

September 26, 2024

Contributed by:

September 26, 2024

Contributed by:

Reconfiguring a Pool to Use Another WLB Appliance

To use a different Workload Balancing appliance

Related documentation

XenServer 8

Citrix Hypervisor 8.2 Cumulative Update 1

In this article